A top performer in Flying Aces Old Time Rubber competitions. Easy to build and fly, Miss Canada Junior is a classic high-wing, endurance sport flyer. Pre-1942 design, eligible for Society of Antique Modelers (SAM) contests. This model may also be converted to CO2 power, instructions are available upon request.
This free flight rubber powered kit contains a full-size rolled plan, hand-sorted printed balsa and balsa strip wood, rubber motor, EB propeller, EBM thrust bearing, clear plastic for the windshield, wheels, wire for landing gear, and Easy Built Lite tissue in a variety of bright colors. To build this kit you will need a building board, hobby knife, fine sandpaper, and glue.
CUSTOMER BUILDS & INFO
"Here's my Miss Canada Jr before the OOS. I loved the kit." - Bill Piatek
"This weekend I flew for the first time Miss Canada Jr. I bought from you before Christmas. It flew perfectly from its first flight, all it needed was a little shim to tighten the climb under power. I did not even need to add weight to balance it, only change is using smaller lighter wheels to keep it's CG back and was done before a test flight. I did not fly it at full power because I did not install D/T and still it flew almost out of sight. There was no wind and airplane always landed within 30 feet from the launch site, once even at my feet. A couple of times after ROG from the runway R/C guys use, it came back and landed at almost same spot. R/C people could not believe it." Paul Kramosil
| Attribute name | Attribute value |
|---|
| Wingspan | 25" |
| Classification | Old Time Rubber, Endurance Aircraft |
